GYEON Q²M Polish Polishing Pad (Rotary / Eccentric) 2 Stück

Fine correction and gloss in one pad – GYEON Q²M Polish polishing pad

What is the GYEON Q²M Polish polishing pad? The GYEON Q²M Polish polishing pad is a soft to medium foam pad for rotary and dual-action machines – built for fine correction and gloss refinement with Q²M Polish, sitting between the correction step and the final finishing pass.

In the GYEON pad line-up, the Q²M Polish pad sits between correction and finishing – softer than the Cut pad, but still a touch more aggressive than the Finish pad. Paired with Q²M Polish you get a single pass that does the fine correction (light compound holograms) and builds gloss at the same time.

• Soft-to-medium foam cell design for fine correction and gloss. The Q²M Polish pad is firmer than a pure finishing pad but softer than a correction pad – exactly the hardness you want for the fine-correction stage, where you clear the last compound holograms and pull maximum gloss out of the paint at the same time.
• Tuned for Q²M Polish – clean product release. The foam cell structure of the Polish pad is matched to how fine the Q²M Polish abrasives are: it picks the polish up and lays it back down evenly, so the result stays consistent and streak-free across the whole panel.
• Runs on rotary and dual-action machines. You can use the Q²M Polish pad on both machine types – on the DA for safe, forgiving finishing, on the rotary at low speed for serious gloss on big panels.

Day-to-day from Detailing1: Run the Q²M Polish pad at medium machine speed (DA setting 5–6, rotary 1000–1200 rpm). Take the last pass on each panel slow and overlapping – that is how you keep it streak-free. After the polishing step, check the result under a halogen or LED work lamp: fine holograms are much harder to spot in direct sunlight than under artificial raking light.

The Q²M Polish pad in a three-stage polish

In a three-stage polish the Polish pad takes the middle slot: Heavy Cut pad + Q²M Compound+ for heavy defects → Q²M Polish pad + Q²M Polish for fine correction and the first round of gloss → Finish pad + Q²M Polish for the final refinement. The Polish pad knocks the Compound+ holograms back and already does most of the gloss work – which leaves the closing finish step as a short but important tidy-up.

Q²M Polish pad for a one-step polish

On cars with light to medium defects, the Polish pad + Q²M Polish works as your only polishing combo in a one-step. The Polish pad has enough bite for fine swirls and wash marks and enough softness for high gloss without holograms. That combination is ideal for the yearly refresh polish on a well-kept car – no compound needed, minimal clear coat taken off, best possible result.

Pad care and service life

Look after the Q²M Polish pad and it lasts. Clean it with a pad brush under running water after every polishing session. The finer foam structure of the Polish pad (softer than Heavy Cut or Cut) takes heavy loading less well – when the machine work gets brutal, switch to firmer pads and spare the Polish pad. Dry it flat, and never store it compressed.

Buying tip: the complete GYEON polishing pad system

The Q²M Polish polishing pad is a core part of the complete GYEON polishing system. As a full set: Heavy Cut pad + Cut pad + Q²M Polish pad + Finish pad – all four polishing stages covered. Add the lambswool pads (Rotary Wool Heavy Cut and Rotary Wool Cut) for the rotary and you have the most complete polishing pad set-up for professional paint correction.